Using Dhcp/Bootp; Figure 3-7 Dhcp Ip Configuration - SMC Networks TIGERSWITCH SMC6752AL2 Management Manual
Tigerswitch 10/100 48-port 10/100mbps fast ethernet managed switch
Hide thumbs
Also See for TIGERSWITCH SMC6752AL2:
- Specification sheet (2 pages) ,
- Installation manual (80 pages) ,
- Management manual (516 pages)
Table of Contents
Advertisement
CLI – Specify the management interface, IP address and default gateway.
Console#config
Console(config)#interface vlan 1
Console(config-if)#ip address 10.1.0.254 255.255.255.0
Console(config-if)#exit
Console(config)#ip default-gateway 192.168.1.254
Console(config)#
Using DHCP/BOOTP
If your network provides DHCP/BOOTP services, you can configure the
switch to be dynamically configured by these services.
Web – Click System, IP Configuration. Specify the VLAN to which the
management station is attached, set the IP Address Mode to DHCP or
BOOTP. Click Apply to save your changes. Then click Restart DHCP to
immediately request a new address. Note that the switch will also broadcast
a request for IP configuration settings on each power reset.
Note: If you lose your management connection, use a console
connection and enter "show ip interface" to determine the new
switch address.
Figure 3-7 DHCP IP Configuration
B
C
ASIC
ONFIGURATION
4-145
4-249
4-252
3-19
Advertisement
Table of Contents
