Table of Contents
Advertisement
Access authorization
1
P051 . . . Key parameter
0 Parameter cannot be changed
40 Parameter can be changed
P052 . . . Selection of parameters to be displayed
0 Only parameters that are not set to default are visible
3 All parameters are visible
Adjustment of converter rated currents
2
Base Drive Panels are designed to continuously operate at the converter US rated current and then provide
150% overload current for 60 seconds. In order to meet this requirement it is mandatory that P067 be set to a
value of 5. The IEC Class 1 rating provides a higher continuous current but has no overload capability. The
fuses, contactor, power terminals, and power wiring used on base drives have been selected based on the US
rating. Failure to set P067 on Base Drive Panels to the US rating may cause damage to Base Drive Panel
components and void warranty.
Set parameter P067 = 5 "U.S. Rating".
Set parameter P075 = 1 to allow dynamic overload capability.
Adjustment to actual converter supply voltage
3
P078.001 . . . Supply voltage for armature circuit (in volts)
P078.002 . . . Supply voltage for field circuit (in volts)
Input of motor data
4
The motor data as given on the motor rating plate must be entered in parameters P100, P101, P102 and P114.
P100 . . . Rated armature current (in amps)
P101 . . . Rated armature voltage (in volts)
P102 . . . Rated field current (in amps)
P114 . . . Thermal time constant of motor (in minutes). If not known use the default 10-minute value.
Actual speed sensing data
5
Operation with analog tachometer
5.1
P083 = 1:
P741
8-10
The actual speed is supplied from the "Main actual value" channel (K0013)
(terminals XT.103, XT.104)
Tachometer voltage at maximum speed (– 270,00V to +270,00V)
SIMOREG DC Master Base Drive Panel Operating Instructions
Siemens Energy & Automation
Advertisement
Table of Contents
