Table of Contents
Advertisement
LED displays
Run green LED
LED illuminated ⇒
Ready yellow LED
LED illuminated ⇒
Fault red LED
LED illuminated ⇒
LED flashing
8.2.2
User-friendly operator control panel (OP1S)
The optional, user-friendly, operator control panel with plain text display (order no.: 6SE7090-0XX84-2FK0)
can be mounted in the special location provided in the converter door or remotely mounted on the enclosure
door. The OP1S connects to the basic converter interface SST1 at sub D connector X300.
Parameters can be selected directly through input of the parameter number by the keyboard of the OP1S.
The following interrelationships apply:
Basic converter
parameter
Technology board
parameter
For more information on the operation of the OP1S, refer to the power module operating instructions and the
instructions that were provided with the OP1S.
Siemens Energy & Automation
SIMOREG DC Master Base Drive Panel Operating Instructions
in "Torque direction active" state (MI, MII, M0).
(See parameter r000)
in "Ready" state (o1 .. o7).
(See parameter r000)
in "Fault signal present" state (o11)
(See parameter r000)
⇒
An alarm is active (see Faults and Alarms).
Displayed
number
rxxx, Pxxx
Uxxx, nxxx
Hxxx, dxxx
Lxxx, cxxx
Number to be keyed in
on OP1S
(0)xxx
2xxx
1xxx
3xxx
8-3
Advertisement
Table of Contents
