European Terminal Board; Cable; Termination Of Cable End - Mitsubishi FX3G Series User Manual

FX /FX /FX PLC User's Manual - Positioning Control Edition
3G 3U 3UC
Built-in Positioning Functions
• When two wires are connected to one terminal
6.8mm(0.27")
or less
6.8mm(0.27")
or less
3.2

European Terminal Board

The European terminal board is used for the high-speed output special adapter and the FX
output extension block.
3.2.1

Cable

Applicable cables and tightening torques
0.3 mm
Single-wire
(AWG22 to 20)
2-wires
0.3 mm
0.3 mm
Rod
(AWG22-20)
terminal
(Refer to the external
with
view of the rod terminal
insulation
shown in the following
sleeve
figure.)
3.2.2

Termination of Cable End

Directly terminate the end of each stranded cable or single-wire cable without a tool, or use the rod terminal
with insulation sleeve for termination.
• Directly terminate the end of the stranded/single-wire cable:
- Terminate the end of the stranded cable so that "barbed wires"
cannot protrude.
- Do not solder-plate the end of the cable.
• Terminate the cable end using a rod terminal with insulation sleeve:
If the cable sheath is too thick, it may be difficult to insert the cable
into the insulation sleeve. For this reason, select an appropriate cable
while referring to the external view.
Manufacturer
Phoenix Contact
B - 32
φ 3.7(0.15")
6.0mm(0.24")
or more
φ 3.7(0.15")
6.0mm(0.24")
or more
Wire size (stranded/ Tightening
single wire)
2 2
to 0.5 mm
2
(AWG22)
2 2
to 0.5 mm
0.25 N
Model
AI 0.5-8WH
3 Connection of Input/Output Lines and Tightening
Terminal
torque
• To connect a stranded cable, peel the sheath off the cable,
and then twist the core before connection.
• To connect a single-wire cable, just peel the sheath off the
cable before connection.
0.22 to
• Rod terminal with insulation sleeve
m
(recommended terminal)
•
AI 0.5-8WH: Manufactured by Phoenix Contact
• Caulking tool:
CRIMPFOX ZA 3: Manufactured by Phoenix Contact
(or CRIMPFOX UD 6: Manufactured by Phoenix Contact)
Caulking tool
CRIMPFOX ZA 3
(or CRIMPFOX UD 6)
3.2 European Terminal Board
Terminal Crimp
screw terminal
2NC
Termination
• Stranded wire/solid wire
9mm
(0.36")
• Bar terminal with insulating sleeve
Insulating sleeve Contact portion
2.6mm
(0.11")
14mm(0.56")
Series input/
(Crimp area)
8mm
(0.32")