Mitsubishi FX3G Series User Manual page 200

FX /FX /FX PLC User's Manual - Positioning Control Edition
3G 3U 3UC
Built-in Positioning Functions
3
Click on the "Positioning" tab, and then set Y000 (pulse output destination)
as follows.
Before clicking on the "Positioning" tab, click on the "Memory Capacity" tab, and then enter a check in the
"Positioning" check box. After entering a check, positioning data can be set.
After entering a check, positioning data can be set. Use the FX
to use "Positioning".
*1. Only available for FX
4
Click on the "Individual setting" button. The "Individual setting" setting
window will appear. In this window, click on the "Y000" tab to display the
positioning table for Y000 (pulse output destination). Set the data in the
positioning table as follows:
B - 162
and FX PLCs.
3U 3UC
12.4 Positioning Using Batch Setting Method
/FX PLC of Ver.2.20 or later or FX
3U 3UC
Setting item
Bias speed (Hz)
Maximum speed (Hz)
Creep speed (Hz)
Zero return speed (Hz)
Acceleration time (ms)
Deceleration time (ms)
Interrupt input for DVIT instruction
Setting item
Rotation direction signal
First device
Positioning type
No. 1
Number of pulses (PLS)
Frequency (Hz)
Positioning type
No. 2
Number of pulses (PL
Frequency (Hz)
Positioning type
No. 3
Number of pulses (PLS)
Frequency (Hz)
Positioning type
No. 4
Number of pulses (PLS)
Frequency (Hz)
12 Examples of Programs
PLC
3G
Setting value
500
100,000
1000
50,000
100
100
*1
X000
Setting value
Y004
R0
DDRVI
(drive to increment)
999,999
30,000
DDRVI
(drive to increment)
S
) -999,999
30,000
DDRVA
(drive to absolute)
500,000
100,000
DDRVA
(drive to absolute)
100
100,000