Omron GX-ID1611 User Manual page 295

Error Descriptions
This section describes the information that is given for individual errors.
 Controller Error Descriptions
The items that are used to describe individual errors (events) are described in the following copy of
an error table.
Event name Gives the name of the error.
Meaning Gives a short description of the error.
Source Gives the source of the error.
Error attributes Level
Effects User program
Indicators Gives the status of the built-in EtherNet/IP port and built-in EtherCAT port indicators. Indicator status is given only for
errors in the EtherCAT Master Function Module and the EtherNet/IP Function Module.
System-defined Variable name
variables
Lists the variable names, data types, and meanings for system-defined variables that provide direct error notification,
that are directly affected by the error, or that contain settings that cause the error.
Cause and Assumed cause
correction
Lists the possible causes, corrections, and preventive measures for the error.
Attached This is the attached information that is displayed by the Sysmac Studio or an NS-series PT.
information
Precautions/Rem Provides precautions, restrictions, and supplemental information.
arks
*1 One of the following:
Major fault: Major fault level
Partial fault: Partial fault level
Minor fault: Minor fault level
Observation
Information
*2 One of the following:
Automatic recovery: Normal status is restored automatically when the cause of the error is removed.
Error reset: Normal status is restored when the error is reset after the cause of the error is removed.
Cycle the power supply: Normal status is restored when the power supply to the Controller is turned OFF and then back
ON after the cause of the error is removed.
Controller reset: Normal status is restored when the Controller is reset after the cause of the error is removed.
Depends on cause: The recovery method depends on the cause of the error.
*3 One of the following:
System: System event log
Access: Access event log
*4 One of the following:
Continues: Execution of the user program will continue.
Stops: Execution of the user program stops.
Starts: Execution of the user program starts.
GX-series EtherCAT Slave Unit User's Manual
Source details
Tells the level of Recovery
influence on
control.*1
Tells what will Operation
happen to
execution of the
user program.*4
Data type
Correction
12 Troubleshooting and Maintenance
Event code Gives the code of the error.
Gives details on Detection timing
the source of the
error.
Gives the Log category
recovery
*2
method.
Provides special information on the operation that results
from the error.
Meaning
Prevention
Tells when the
error is detected.
Tells which log
the error is saved
12
*3
in.
12 - 15