Table of Contents
Advertisement
10 IO-Link Master Unit
Function name
Load rejection for controller
communications error
IO-Link total communications lost
frames
Digital input filter
Digital input collection
(Unit version 1.1 or later)
Backup and restoration of parameter
settings in IO-Link devices
Event log
10 - 8
This function turns OFF outputs from the IO-Link Master Unit when an
error occurs in communications with the controller in IO-Link Mode or in
an SIO mode.
This prevents output operations with incorrect values when a
communications error occurs.
The IO-Link total communications lost frames can be read from the
CX-ConfiguratorFDT.
You can use this function to determine communications status as
affected by IO-Link communications noise or other factors.
You can remove the chattering and noise of the input signal for digital
inputs in SIO (DI) Mode or for digital inputs for pin 2 in IO-Link Mode.
When the input data changes without stabilization of the state of the
contact point due to chattering and noise, this function prevents
changes in data and stabilizes it.
In IO-Link Mode, this function reflects the specified bit data in the input
data from the IO-Link device on the digital input data of the IO-Link
Master Unit. As a result, the bit data in the input data from the IO-Link
device can be aggregated into the digital input data of the IO-Link
Master Unit. One bit for each IO-Link port can be aggregated. This
function cannot be used in SIO (DI) Mode and SIO (DO) Mode.
If you are using this function, you cannot perform digital inputs for pin 2.
This function is used to back up parameter settings in IO-Link devices in
the IO-Link Master Unit or restore them to IO-Link devices.
This eliminates the need to set parameters again after replacing an
IO-Link device.
This function records events, such as errors and status changes, that
occur in the IO-Link Master Unit and IO-Link devices.
Description
GX-series EtherCAT Slave Unit User's Manual
Hide quick links:
Advertisement
Table of Contents
