Measured Value Display; Table 6-6 Measurement Type / Device Variables Display - Siemens SITRANS P300 Operating Instructions Manual

Operation
6.5 Local operation
6.5.14

Measured value display

Introduction
The following types of measured value display are set in mode 13:
• mA
• %
• Measurement type "Pressure", if no other setting has been made via HART
Table 6-6
DV
0
1
2
3
4
5
6
7
8
9
Requirement
You are familiar with the correct operation of the transmitter and the associated safety
information.
Procedure
To select the display type, proceed as follows:
1. Set mode 13.
2. Select the measured value display.
3. Save with the <Mode> key.
See also
Operating via keys (Page 6-12)
Measured value display (Page 7-21)
6-32
communication.
Measurement type / Device variables display
Meaning
Pressure
Sensor temperature
Electronics temperature
Pressure value (untrimmed)
Level
Volume
Mass
Volume of flow
(not relevant for gauge and absolute pressure)
Mass flow rate
(not relevant for gauge and absolute pressure)
User
Digital display
P
t-SE
t-EL
P-UNC
LEVEL
Vol
MASS
V-Flo
M-Flo
CUSt
SITRANS P300 with HART communication
Operating Instructions, 06/2005, A5E00359579-02