Custom Conversion Factor; Decimal Places; Low Flow Cut-Off - Siemens FST020 Function Manual

Related
Path
3.2.1.3

Custom conversion factor

Description
Conversion factor for user specific standard volume flow values related to SI m³/s.
Setting
Default
Related
Path
3.2.1.4

Decimal places

Description
Sets the decimal places for the process value displayed in the local display.
Setting
Default
Related
Path
3.2.1.5

Low flow cut-off

Description
Volume flow limit for low flow cut off. Below limit volume flow output is forced to zero.
Setting
Default
Related
Path
FST020 Function manual
Function Manual, 09/2017, A5E42949526-AA
Setup → Process values → Volume flow → Custom units
-
1.0
Setup → Process values → Volume flow → Custom conversion factor
Auto; No decimal place; 1 decimal place; 2 decimal places; 3 decimal places; 4 decimal
places; 5 decimal places; 6 decimal places
2 decimal places
Setup → Process values → Standard volume flow → Decimal places
0.00 m /h to 896.40 m /h (depends on sensor)
3 3
0.1% of maximum flow (depends on sensor)
Setup → Process values → Volume flow → Low flow cut-off
Setup
3.2 Process values
39