C-4 Perform Engine Maintenance - Ford Models - Genie Z-60/34 Service Manual

November 2003
REV A
10 Test all machine functions from the ground
controls.
Result: All ground control functions should not
operate.
Machine functions should still
operate with auxiliary power at the
ground controls.
11 Lift the test weights off the platform floor using a
suitable lifting device.
Result: The platform overload indicator light and
alarm should turn off at both the ground and
platform controls.
There may be an approximate 2
second delay before the overload
indicator light and alarm turn off.
12 Test all machine functions from the ground
controls.
Result: All ground control functions should
operate normally.
13 Turn the key switch to platform control.
14 Test all machine functions from the platform
controls.
Result: All platform control functions should
operate.
If the platform overload system is
not operating properly, see D-6,
How to Calibrate the Platform
Overload System.
Part No. 75861
Section 3 • Scheduled Maintenance Procedures
C-4
Perform Engine Maintenance -
Ford Models
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Required maintenance procedures and additional
engine information are available in the
Ford LRG-425 EFI Operator Handbook
(Ford part number FPP 194-302).
Ford LRG-425 EFI Operator Handbook
Genie part number
To access the engine:
1 Remove the two engine pivot plate retaining
bolts. Swing the engine pivot plate out away
from the machine and secure it from moving.
Genie Z-60/34
CHECKLIST C PROCEDURES
Ford engine specifications require
that this procedure be performed
every 800 hours.
Crushing hazard. Failure to secure
the engine pivot plate from moving
could result in death or serious
injury.
77831
3 - 39