Genie Z-60/34 Service Manual page 64

Section 3 • Scheduled Maintenance Procedures
CHECKLIST D PROCEDURES
4 Disengage the drive hubs by turning over the
drive hub disconnect caps on each
non-steer wheel hub.
5 Manually rotate each non-steering wheel.
Result: Each non-steering wheel should rotate
with minimum effort.
6 Re-engage the drive hubs by turning over
the hub disconnect caps. Rotate each wheel to
check for engagement. Lift the machine and
remove the jack stands.
Collision hazard. Failure to
re-engage the drive hubs may
cause death or serious injury and
property damage.
4WD models:
7 Chock the non-steer wheels to prevent the
machine from rolling.
8 Center a lifting jack of ample capacity
under the drive chassis between the steer
wheels.
9 Lift the wheels off the ground and then place
blocks under the drive chassis for support.
3 - 42
disengaged position
engaged position
Genie Z-60/34
10 Disengage the drive hubs by turning over the
drive hub disconnect caps on each steer wheel
hub.
11 Manually rotate each steer wheel.
Result: Each steer wheel should rotate with
minimum effort.
12 Engage the drive hubs by turning over
the drive hub disconnect caps. Rotate each
wheel to check for engagement. Lift the
machine and remove the blocks.
Collision hazard. Failure to
engage the drive hubs could result
in death or serious injury and
property damage.
November 2003
REV A
disengaged position
engaged position
Part No. 75861