Perform Engine Maintenance - Ford Models; Check For Fuel Leaks - Genie Z-60/34 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
A-3
Perform Engine Maintenance -
Ford Models
Engine specifications require that
this procedure be performed daily
or every 8 hours, whichever comes
first.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Required maintenance procedures and additional
engine information are available in the
Ford LRG-425 EFI Operator Handbook
(Ford part number FPP 194-302).
Ford LRG-425 EFI Operator Handbook
Genie part number
To access the engine:
1 Remove the two engine pivot plate retaining
bolts. Swing the engine pivot plate out away
from the machine and secure.
Crushing hazard. Failure to secure
the engine pivot plate from moving
could result in death or serious
injury.
3 - 8
A-4

Check for Fuel Leaks

Failure to detect and correct fuel leaks will result in
an unsafe condition. An explosion or fuel fire may
cause death or serious injury.
1 Open the shutoff valve on the liquid petroleum
gas (LPG) tank by turning it counterclockwise
(if equipped).
2 Perform a visual inspection around the following
areas.
Ford Models:
77831
· LPG tank, hoses and fittings, solenoid shutoff
valve, LPG regulator and throttle body.
· Fuel tank, fuel pump, fuel filters, fuel rail and
fuel injectors, hoses and fittings and throttle
body.
Deutz Models:
· Fuel tank, hoses and fittings,
fuel pump, fuel filter, fuel injection pumps and
fuel injectors.
Genie Z-60/34
November 2003
Explosion and fire hazard. Engine
fuels are combustible. Inspect the
machine in an open, well-ventilated
area away from heaters, sparks,
flames and lighted tobacco.
Always have an approved fire
extinguisher within easy reach.
An LPG detector may be
necessary to locate LPG leaks.
Explosion and fire hazard. If a fuel
leak is discovered, keep any
additional personnel from entering
the area and do not operate the
machine. Repair the leak
immediately.
Part No. 75861
REV A