Genie Z-60/34 Service Manual page 108

Section 4 • Repair Procedures
ENGINES
6 Refer to the Fault Code Section for definition of
engine fault codes.
Once a fault code has been
retrieved and the repair has been
completed, the ECM memory
must be reset to clear the fault
code from the ECM. See How to
Clear Engine Fault Codes.
How to Clear Engine Fault Codes
from the ECM
Perform this procedure with the
engine off and the key switch in
the off position.
1 Open the engine side turntable cover and locate
the battery.
2 Disconnect the negative battery cable from the
battery for a minimum of 5 minutes.
Electrocution hazard. Contact with
electrically charged circuits could
result in death or serious injury.
Remove all rings, watches and
other jewelry.
3 Connect the negative battery cable to the
battery.
4 - 34 Genie Z-60/34
November 2003
REV A
Part No. 75861