Perform Engine Maintenance - Ford Models - Genie S-40 Service Manual

October 2013
a fuel filter
b drain plug
2 Clean up any fuel that may have spilled.
3 Start the engine from the ground controls and
check the fuel filter/water separator for leaks.
Explosion and fire hazard. If a fuel
leak is discovered, keep any
additional personnel from entering
the area and do not operate the
machine. Repair the leak
immediately.
Part No. 102521
Section 3 • Scheduled Maintenance Procedures
A-11
Perform Engine Maintenance -
Ford Models
a
b
Engine specifications require that this procedure be
performed every 100 hours.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life.
Failure to perform the maintenance procedures
can lead to poor engine performance and
component damage.
Required maintenance procedures and additional
engine information are available in the
Ford LRG-425 EFI Operator Handbook
(Ford part number FPP 194-302) or the
Ford DSG-423 EFI Operator Handbook
(EDI part number 1060020) or the
Ford MSG-425 EFI Operator Handbook
(Ford part number 1020010) .
Ford LRG 425 EFI Operation Manual
Genie part number
Ford DSG 423 EFI Operator Handbook
Genie part number
Ford MSG-425 EFI Operator Handbook
Genie part number
To access the engine:
Remove the engine tray retaining fasteners
located under the engine tray. Loosen the pivot
fastener located at the platform end of the
engine tray. Swing the engine tray out and
away from the machine and secure it from
moving.
S-40 • S-45
CHECKLIST A PROCEDURES
Crushing hazard. Failure to secure
the engine pivot plate from moving
could result in death or serious
injury.
84792
119488
215322
3 - 13