Section 4 • Repair Procedures
PRIMARY BOOM COMPONENTS
5 Attach a lifting strap from an overhead crane to
the lug on the rod end of the master cylinder.
6 Remove the pin retaining fasteners from the
master cylinder barrel-end pivot pin. Use a soft
metal drift to remove the pin.
7 Lower the master cylinder down and out of the
upper pivot and remove it from the machine.
Crushing hazard. The master
cylinder could become unbalanced
and fall when removed from the
machine if not properly attached to
the overhead crane.
4 - 24
Genie Z-60/34
November 2003
REV A
Part No. 75861