Perform Engine Maintenance - Gm And Ford Models - Genie S-65 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
A-3
Perform Engine Maintenance -
Deutz Models
Engine specifications require that
this procedure be performed daily
or every 10 hours, whichever
comes first.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Required maintenance procedures and additional
engine information are available in the
Deutz FL 2011 Operation Manual
(Deutz part number 0297-9929).
Deutz FL 2011 Operation Manual
Genie part number
To access the engine:
1 Remove the engine tray retaining fastener
located under the engine tray. Swing the engine
tray out and away from the machine.
2 Install the fastener that was just removed
through the engine tray and into the engine tray
anchor hole in the turntable.
Crushing hazard. Failure to install
the fastener into the engine tray
anchor hole to secure the engine
tray from moving could result in
death or serious injury.
3 - 8
A-4
Perform Engine Maintenance -
GM and Ford Models
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Required maintenance procedures and additional
engine information are available in the
GM 3.0L Operator Handbook
(GM part number 36100007) or the
Ford LRG-425 EFI Operator Handbook
(Ford part number FPP 194-302).
84794
GM 3.0L Operator Handbook
Genie part number
Ford LRG 425 EFI Operator Handbook
Genie part number
To access the engine:
1 Remove the engine tray retaining fastener
located under the engine tray. Swing the engine
tray out and away from the machine.
2 Install the fastener that was just removed
through the engine tray and into the engine tray
anchor hole in the turntable.
S-60 • S-65
Engine specifications require that
this procedure be performed daily
or every 8 hours, whichever comes
first.
Crushing hazard. Failure to install
the fastener into the engine tray
anchor hole to secure the engine
tray from moving could result in
death or serious injury.
Part No. 77828
July 2005
REV C
101095
84792