Supporting procedures
Replacing System Components
....................................................................................................................................................................................................................................
...................................................................................................................................................................................................
Click
Alarms
25
present in the Alarm List.
If...
the SWUPGCOMMIT alarm is raised,
the SWUPGCOMMIT alarm is not raised,
...................................................................................................................................................................................................
Select
26
Result:
...................................................................................................................................................................................................
In the Action field, select
27
...................................................................................................................................................................................................
28
Click
Apply
...................................................................................................................................................................................................
Click
Alarms
29
Result:
present in the Alarm List.
E
N D
O F
...................................................................................................................................................................................................
To Replace a Simplex Equipment Controller Using CLI
...................................................................................................................................................................................................
Ensure that you are working with a valid database. Set up the database server information.
1
Type each command line, and press Enter:
1. Type
2.
config database server ip
database is stored.
3.
config database userid
4.
config database path
saved.
5.
config database detail
...................................................................................................................................................................................................
2
Backup the database by typing:
....................................................................................................................................................................................................................................
3-46
. The Alarms List is displayed. The SWUPGCOMMIT alarm should not be
>
Administration
Software
The Software Upgrade window is displayed.
Commit
.
.
The Alarms List is displayed. The SWUPGCOMMIT alarm should not be
S T E P S
database server config
Replacing an Equipment Controller in a Nonredundant Shelf
Then...
continue with
STOP! You are done with this procedure.
>
.
Upgrade
.
.
IP Address, using the IP address where the
, then enter your user ID and password when prompted.
directory with the path on the PC where the database is
to verify your IP address, user ID, and path.
Step
26.
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011