Alcatel-Lucent 1830 PSS-16 Maintenance And Trouble-Clearing User Manual page 648

Supporting procedures
Replacing System Components
....................................................................................................................................................................................................................................
Replacing an Equipment Controller in a Redundant Shelf
Replacing an Equipment Controller in a redundant shelf is not service-affecting.
Before you begin this procedure ensure that the following conditions are met:
• The NE is quiet (that is, there are no commands issued to it other than those needed
for this procedure).
• The Equipment Controller you plan to insert into this duplex controller NE, as the
replacement, is approved for duplex controller configurations, Alcatel-Lucent Part
Number (APN) = 8DG59241AB.
To perform this procedure using the WebUI, go to
a Shelf with Redundant Equipment Controllers Using the WebUI" (p.
To perform this procedure using the CLI, go to
Shelf with Redundant Equipment Controllers Using the CLI" (p.
To replace a Equipment Controller in a Shelf with Redundant Equipment Controllers Using the
WebUI
The Equipment Controller is hot-swappable, allowing in-service replacement. This
procedure is not service-affecting.
...................................................................................................................................................................................................
1 Retrieve which Equipment Controller is active. If the Equipment Controller that is to be
replaced is the active Equipment Controller for this shelf, then switch to the other
Equipment Controller. In the Equipment Tree, select the slot containing the Equipment
Controller.
Result:
...................................................................................................................................................................................................
2 Click the Protection Switch tab.
...................................................................................................................................................................................................
The EC Protection Software Settings window is displayed.
3
Note: The Protection Setting field is set to
...................................................................................................................................................................................................
To switch the Equipment Controller, select
4
...................................................................................................................................................................................................
5 Unplug any Ethernet or serial cables that are connected to the Equipment Controller to be
replaced.
...................................................................................................................................................................................................
Remove and replace the card (see
6
....................................................................................................................................................................................................................................
3-40
The Card Properties window is displayed.
Replacing an Equipment Controller in a Redundant Shelf
"To replace a Equipment Controller in
"To replace a Equipment Controller in a
Active .
Enable Protection Switch
"Replacing a Card (General)" (p.
3-40).
3-41).
, and click Submit
3-22)).
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
.