Alcatel-Lucent 1830 PSS-16 Maintenance And Trouble-Clearing User Manual page 626

Supporting procedures
Software Upgrades
....................................................................................................................................................................................................................................
...................................................................................................................................................................................................
Configure the database server setting and restore the valid R2.5 database.
5
CLI
WEBUI
...................................................................................................................................................................................................
One the database is restored successfully, perform the software upgrade procedure for
6
R2.5.
n
E
N D O F
...................................................................................................................................................................................................
Rebooting Components
Cold Restart of a Pack with Traffic
Performing a cold restart of a transmission-carrying pack is service affecting. Thus, cold
restart is not allowed on packs when they are in-service. (The pack must either be in
maintenance state, or out-of-service.)
The following procedure is a workaround to perform a cold restart on a
transmission-carrying card for special reasons, such as verifying whether transmission
recovers after the restart is completed.
...................................................................................................................................................................................................
1 Put the card (and ports) into maintenance state before performing the cold restart. In
maintenance state, the cross connects can remain in place, and transmission is still
carried.
CLI
....................................................................................................................................................................................................................................
3-18
1.
config database server
Add the next applicable command to the string as follows:
•
detail—Display software server information
•
ip—Configure the remote backup/restore server IP address
•
protocol—Configure the remote backup/restore protocol
•
userid—Configure the userid for accessing the backup/restore serve
2.
config database path
3.
config database restore
See "Restoring a Database" (p. 3-14)
to R3.0.2.
S T E P S
For cards:
config slot state mt
For ports:
config interface state mt
Restoring an NE in DBINVALID State
for applicable steps.
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011