Alcatel-Lucent 1830 PSS-16 Maintenance And Trouble-Clearing User Manual page 304

Trouble-clearing procedures
CONTCOM
....................................................................................................................................................................................................................................
communications and timing cable and see if the link comes back up.
E
N D O F
...................................................................................................................................................................................................
CONTEQPT
CONTEQPT (Card Failure - Device)
The CONTEQPT condition indicates a fault on the Equipment Controller that has caused
the system to declare a hardware failure. This condition may be declared due to a failure
in the SEEP or other unknown hardware failures. This is a major non-service affecting
alarm for the Equipment Controller and causes a redundancy switch to the mate.
Severity
Service affecting?
Applicability
Corrective Action
A cold reset, reseat, or replacement of a card is service impacting if the card is currently
carrying services. To determine if any services are currently carried over a card, perform
the procedure
If there are services currently carried over the card, it may be best to wait for a
maintenance window before resetting, replacing, or reseating the card.
At the end of each step wait to see if the fault clears. If not, continue with the next step.
...................................................................................................................................................................................................
Perform a warm reset of the card.
1
CLI
WEBUI
...................................................................................................................................................................................................
Perform a cold reset of the card.
2
....................................................................................................................................................................................................................................
2-54
S T E P S
Major
No
Equipment Controller, FLC
NOTICE
Service-disruption hazard
"Reseating a Card" (p.
config card
Select the card, click the
CONTCOM (Inter-shelf loss of communication)
3-19).
card type shelf slot
reset warm
Reboot tab, select Warm Reboot > Submit .
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011