Alcatel-Lucent 1830 PSS-16 Maintenance And Trouble-Clearing User Manual page 359

Trouble-clearing procedures
FWVERSIONNOTDEFAULT
....................................................................................................................................................................................................................................
At the end of each step wait to see if the fault clears. If not, continue with the next step.
...................................................................................................................................................................................................
1 Check that the default firmware bundle is provisioned for the card.
CLI
...................................................................................................................................................................................................
If the default firmware bundle is not provisioned in the previous step, then provision the
2
default firmware bundle for the card.
CLI
...................................................................................................................................................................................................
Perform a cold reset of the card.
3
Note: Refer to Caution at the beginning of this procedure.
CLI
WEBUI
...................................................................................................................................................................................................
Contact your next level of support.
4
E
N D O F
...................................................................................................................................................................................................
HIBER
HIBER (High BER)
The OT port has detected a High BER on 10GbE LAN facility. This defect indicates that
local 10GbE LAN port has detected BER > 10-4 (high BER defect is triggered when
more than 16 invalid 64B/66B sync headers get detected within 125us).
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
show firmware card
config firmware card
card_type shelf slot
config card
Select the card, click the
S T E P S
FWVERSIONNOTDEFAULT (Firmware version on this pack is
not the default version for this software release)
card_type shelf slot
card_type shelf slot
card_type shelf slot
reset cold
tab, select
Reboot
detail
config firmware card
> .
Cold Reboot Submit
2-109