Alcatel-Lucent 1830 PSS-16 Maintenance And Trouble-Clearing User Manual page 337

Trouble-clearing procedures
EBER
....................................................................................................................................................................................................................................
...................................................................................................................................................................................................
4 If...
no active traffic is present on the system,
the optical power is below the required
threshold for the type of pluggable module
installed,
the optical power is within the required limits,
...................................................................................................................................................................................................
5
Note: Refer to Caution at the beginning of this procedure.
Perform a warm reset of the card exhibiting the Loss of Frame.
CLI
WEBUI
...................................................................................................................................................................................................
Perform a cold reset of the card exhibiting the Loss of Frame.
6
CLI
WEBUI
...................................................................................................................................................................................................
Reseat the card. Refer to
7
...................................................................................................................................................................................................
8 Replace the OSC SFP located inside the amplifier. See
(p. 3-27). Follow the return and repair process in the Customer and Product Support guide
to return the faulty pluggable module to an authorized repair center for replacement.
...................................................................................................................................................................................................
9 Replace the card. Refer to
and repair process in the Customer and Product Support guide to return the faulty card to
an authorized repair center for replacement.
E
N D O F
...................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
config card
Select the card, click the
config card
Select the card, click the
"Reseating a Card" (p.
"Replacing System Components" (p.
S T E P S
EBER-O (Optical Supervision Channel Excessive BER)
Then...
remove the fiber from the receive port where
the EBER-O is raised and measure the optical
power.
using the standard optical fiber jumper
cleaning procedure, clean the fiber, and
measure the power again.
clean the receive connector on the card. If the
EBER-O condition is still present, the problem
may be with the card.
card type shelf slot
reset warm
Reboot tab, select
card type shelf slot
reset cold
tab, select
Reboot
3-19).
Warm Reboot > Submit
>
Cold Reboot Submit
"Replacing an SFP Module"
3-20). Follow the return
.
.
2-87