Alcatel-Lucent 1830 PSS-16 Maintenance And Trouble-Clearing User Manual page 453

Trouble-clearing procedures
NET
....................................................................................................................................................................................................................................
...................................................................................................................................................................................................
Remove the fiber from the port where the NET condition is raised.
2
...................................................................................................................................................................................................
3 Check the power using a power meter.
...................................................................................................................................................................................................
Clean the fiber and the bulkhead connector.
4
...................................................................................................................................................................................................
5 Repeat
...................................................................................................................................................................................................
Repeat
6
...................................................................................................................................................................................................
Replace the fiber jumper with a new one.
7
...................................................................................................................................................................................................
Perform a warm reset on the card that is the source of the Ethernet signal.
8
CLI
WEBUI
...................................................................................................................................................................................................
Perform a warm reset on the card where the NET condition is raised.
9
CLI
WEBUI
...................................................................................................................................................................................................
Perform a cold reset on the card that is the source of the Ethernet signal.
10
CLI
WEBUI
...................................................................................................................................................................................................
Perform a cold reset on the card where the LINKDOWN condition is raised.
11
...................................................................................................................................................................................................
12 Reseat the card that is the source of the Ethernet signal.
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
Step 2 through Step 4
Step 4.
config card
Select the card, click the
config card
Select the card, click the
config card
Select the card, click the
for the other end of the fiber and port where it is connected.
card_type shelf slot
reset warm
Reboot tab, select
card type shelf slot
reset warm
Reboot tab, select
card type shelf slot
reset cold
tab, select
Reboot
NET (Link Down; Data Link Down)
Cold Reboot > Submit .
Warm Reboot > Submit .
> .
Cold Reboot Submit
2-203