Alcatel-Lucent 1830 PSS-16 Maintenance And Trouble-Clearing User Manual page 484

Trouble-clearing procedures
OPRPWRHIGH
....................................................................................................................................................................................................................................
WEBUI
...................................................................................................................................................................................................
2
If...
the power levels are within the acceptable
limits,
the power levels are not within acceptable
limits,
...................................................................................................................................................................................................
Thoroughly clean the fiber jumper connected to the LINE or SIG port of the amplifier
3
card raising the alarm.
...................................................................................................................................................................................................
Thoroughly clean the fiber bulkhead connector of the LINE or SIG port of the amplifier
4
card raising the alarm.
...................................................................................................................................................................................................
5 Perform a warm reset on the card where the OPR condition is raised.
CLI
WEBUI
...................................................................................................................................................................................................
Perform a cold reset of the card.
6
Note: Refer to Caution at the beginning of this procedure.
CLI
WEBUI
...................................................................................................................................................................................................
Reseat the card. Refer to
7
...................................................................................................................................................................................................
Replace the card. Refer to
8
and repair process in the Customer and Product Support guide to return the faulty card to
an authorized repair center for replacement.
E
N D O F
...................................................................................................................................................................................................
....................................................................................................................................................................................................................................
2-234
From the Equipment Tree, select the card, and select the desired port.
config card
Select the card, click the
config card
Select the card, click the
"Reseating a Card" (p.
"Replacing System Components" (p.
S T E P S
OPRPWRHIGH (Out of Operational Range - Input Power Too
Then...
the problem may be with the card itself.
Proceed to
continue with
card_type shelf slot
reset warm
Reboot tab, select
card_type shelf slot
reset cold
Reboot tab, select
3-19).
Step 5.
Step 3.
Warm Reboot > Submit
Cold Reboot > Submit
3-20). Follow the return
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
High)
.
.