Table of Contents
Advertisement
Figure 35: SNMP Notification Filter
The following items are displayed on this page:
Filter ID — A user-defined name that identifies the filter. (Maximum
◆
length: 32 characters)
Subtree — Specifies MIB subtree to be filtered. The MIB subtree must
◆
be defined in the form ".1.3.6.1" and always start with a ".".
Type — Indicates if the filter is to "include" or "exclude" the MIB
◆
subtree objects from the filter. Note that MIB objects included in the
filter are not sent to the receiving target and objects excluded are sent.
By default all traps are sent, so you can first use an "include" filter
entry for all trap objects. Then use "exclude" entries for the required
trap objects to send to the target. Note that the filter entries are
applied in the sequence that they are defined.
Action — Adds the notification filter.
◆
– 75 –
| Management Settings
C
6
HAPTER
Simple Network Management Protocol
Advertisement
Table of Contents
