Copy - SMC Networks EliteConnect SMCE21011 User Manual

| Flash/File Commands
C 18
HAPTER

copy

This command copies a boot file, code image, or configuration file between
the access point's flash memory and a FTP/TFTP server. When you save the
configuration settings to a file on a FTP/TFTP server, that file can later be
downloaded to the access point to restore system operation. The success
of the file transfer depends on the accessibility of the FTP/TFTP server and
the quality of the network connection.
S
YNTAX
copy {ftp [firmware | config] <file-name> <ip-address> <user-
name> <password> | tftp [firmware | config] <file-name> <ip-
address>}
copy config {ftp <file-name> <ip-address> <user-name>
<password> | tftp <file-name> <ip-address>}
copy running startup
ftp - Keyword that allows you to copy to/from an FTP server.
tftp - Keyword that allows you to copy to/from a TFTP server.
file - Keyword that allows you to copy to/from a flash memory file.
config - Keyword that allows you to upload the configuration file
from flash memory.
D S
EFAULT ETTING
None
C M
OMMAND ODE
Exec
C U
OMMAND SAGE
The system prompts for data required to complete the copy command.
◆
Only a configuration file can be uploaded to an FTP/TFTP server, but
◆
every type of file can be downloaded to the access point.
The destination file name should not contain slashes (\ or /), the leading
◆
letter of the file name should not be a period (.), and the maximum
length for file names on the FTP/TFTP server is 255 characters or 32
characters for files on the access point. (Valid characters: A-Z, a-z, 0-9,
".", "-", "_")
Due to the size limit of the flash memory, the access point supports
◆
only two operation code files.
The system configuration file must be named "syscfg" in all copy
◆
commands.
E
XAMPLE
The following example shows how to upload the configuration settings to a
file on the TFTP server:
– 168 –