Table of Contents
Advertisement
C
OMMAND
◆
Both HTTP and HTTPS service can be enabled independently.
If you enable HTTPS, you must indicate this in the URL:
◆
https://device:port_number]
When you start HTTPS, the connection is established in this way:
◆
The client authenticates the server using the server's digital certificate.
◆
The client and server negotiate a set of security protocols to use for the
◆
connection.
The client and server generate session keys for encrypting and
◆
decrypting data.
The client and server establish a secure encrypted connection.
◆
A padlock icon should appear in the status bar for Internet Explorer 5.x.
E
XAMPLE
AP(config)#ip https server
AP(config)#
This command specifies the client IP addresses that are allowed
APmgmtIP
management access to the access point through various protocols.
Secure Web (HTTPS) connections are not affected by the UI
N
:
OTE
Management or IP Management settings.
S
YNTAX
APmgmtIP <multiple IP_address subnet_mask | single IP_address |
any>
multiple - Adds IP addresses within a specifiable range to the
SNMP, web and Telnet groups.
single - Adds an IP address to the SNMP, web and Telnet groups.
any - Allows any IP address access through SNMP, web and Telnet
groups.
IP_address - Adds IP addresses to the SNMP, web and Telnet
groups.
subnet_mask - Specifies a range of IP addresses allowed
management access.
D
S
EFAULT
All addresses
C
HAPTER
U
SAGE
ETTING
– 135 –
| System Management Commands
13
System Management Commands
Advertisement
Table of Contents
