Adding A Repeater; Access Filter - SMC Networks SMC EZ Connect g SMCWTK-G User Manual

The following table describes the setup options in detail.
Table 5: AP Advanced Settings
Field Description
Beacon Interval Beacon interval (in milliseconds)
RTS Threshold RTS threshold (in bytes)
DTIM Interval DTIM interval
Allows user to force 802.11g protection (RTS/CTS) mode
Protection Mode
off.
Transmit Rate Selects the transmit rate: Auto or a fixed rate
Preamble Type Selects short preamble, long preamble, or Auto
Connect Repeater Enables/Disables the use of a Repeater
Repeater MAC MAC address of the Repeater, if used
Address

6.3.1 Adding a Repeater

If a Repeater is used along with the Access Point, go to the Advanced
Settings page. Select Enable for the "Connect Repeater" field. Enter the MAC
address of the Repeater in the "Repeater MAC address" field.

6.4 Access Filter

The Access Filter page allows you to configure the AP to allow or deny association
to the AP based on the client's MAC address. Up to 32 MAC addresses can be added to
the list.