Table of Contents
Advertisement
| Wireless Settings
C
8
HAPTER
Radio Settings
Figure 45: Radio Settings
The following items are displayed on this page:
High Throughput Mode — The access point provides a channel
◆
bandwidth of 20 MHz by default giving an 802.11g connection speed of
54 Mbps and a 802.11n connection speed of up to 108 Mbps, and
ensures backward compliance for slower 802.11b devices. Setting the
HT Channel Bandwidth to 40 MHz (sometimes referred to as Turbo
Mode) increases connection speed for 802.11g and 802.11n to 74 Mbps
and 300 Mbps respectively. HT40plus indicates that the secondary
channel is above the primary channel. HT40minus indicates that the
secondary channel is below the primary channel.
(Default: HT20; Range:HT20, HT40PLUS, HT40MINUS)
Some 802.11n wireless clients may be capable of transmission rates
N
:
OTE
of up to 600 Mbps, however the access point will only be able to connect to
them at a maximum transmission rate of 300 Mbps.
Radio Channel — The radio channel that the access point uses to
◆
communicate with wireless clients. When multiple access points are
deployed in the same area, set the channel on neighboring access
points at least five channels apart to avoid interference with each other.
For example, you can deploy up to three access points in the same area
– 90 –
Advertisement
Table of Contents
