Table 8: General Commands - SMC Networks EliteConnect SMCE21011 User Manual

12
configure
G C
ENERAL
This chapter details general commands that apply to the CLI.

Table 8: General Commands

Command Function
configure Activates global configuration mode
end Returns to previous configuration mode
exit Returns to the previous configuration mode, or exits
the CLI
cli-session-timeout Enables, disbles or sets a timeout for the CLI or
Telnet session.
ping Sends ICMP echo request packets to another node
on the network
reset Restarts the system
show history Shows the command history buffer
show line Shows the configuration settings for the console port Exec
This command activates Global Configuration mode. You must enter this
mode to modify most of the settings on the access point. You must also
enter Global Configuration mode prior to enabling the context modes for
Interface Configuration. See "Using the Command Line Interface" on page
1.
D S
EFAULT ETTING
None
C M
OMMAND ODE
Exec
E
XAMPLE
AP#configure
AP(config)#
R C
ELATED OMMANDS
end (123)
– 122 –
OMMANDS
Mode Page
Exec 122
GC, IC 123
any 123
Exec 123
Exec 124
Exec 125
Exec 125
126