Filtering Commands; Table 20: Filtering Commands - SMC Networks EliteConnect SMCE21011 User Manual

22
filter local-bridge
F C
ILTERING
The commands described in this section are used to filter communications
between wireless clients, control access to the management interface from
wireless clients, and filter traffic using specific Ethernet protocol types.

Table 20: Filtering Commands

Command Function
filter local-bridge Disables communication between wireless
clients
filter ap-manage Prevents wireless clients from accessing the
management interface
filter acl-source- Filters the ACL source address
address
filter acl-destination- Filters the ACL destination address
address
filter ethernet-type Checks the Ethernet type for all incoming and
enable outgoing Ethernet packets against the protocol
filtering table
filter ethernet-type Sets a filter for a specific Ethernet type
protocol
show filters Shows the filter configuration
This command disables communication between wireless clients. Use the
no form to disable this filtering.
S
YNTAX
filter local-bridge <all-VAP | intra-VAP>
no filter local-bridge
all-VAP - When enabled, clients cannot establish wireless
communications with any other client, either those associated to
the same VAP interface or any other VAP interface.
intra-VAP - When enabled, clients associated with a specific VAP
interface cannot establish wireless communications with each other.
Clients can communicate with clients associated to other VAP
interfaces.
D
EFAULT
Disabled
C M
OMMAND ODE
Global Configuration
– 181 –
OMMANDS
Mode Page
GC 181
GC 182
GC 182
GC 183
GC 184
GC 184
Exec 185