Bridge-Link Path-Cost - SMC Networks EliteConnect SMCE21011 User Manual

| Ethernet Interface Commands
C 25
HAPTER
shutdown
bridge-link path-
cost
E
XAMPLE
AP(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
AP(if-ethernet)#ip dhcp
AP(if-ethernet)#
R C
ELATED OMMANDS
ip address (196)
This command disables the Ethernet interface. To restart a disabled
interface, use the no form.
S
YNTAX
shutdown
no shutdown
D S
EFAULT ETTING
Interface enabled
C M
OMMAND ODE
Interface Configuration (Ethernet)
C U
OMMAND SAGE
This command allows you to disable the Ethernet port due to abnormal
behavior (e.g., excessive collisions), and reenable it after the problem has
been resolved. You may also want to disable the Ethernet port for security
reasons.
E
XAMPLE
The following example disables the Ethernet port.
AP(if-ethernet)#shutdown
AP(if-ethernet)#
Use this command to configure the spanning tree path cost for the
specified port.
S
YNTAX
bridge-link path-cost <index> <cost>
index - Specifies the bridge link number on the wireless bridge.
(Range: 1-6 required on wireless interface only)
cost - The path cost for the port. (Range: 1-65535)
– 198 –