Replacing The Front Usb Connector; Assembly - Lenovo System x3100 M4 Installation And Service Manual

Front USB connector

assembly

11. Carefully pull the front USB cable out of the opening in the chassis.
12. If you are instructed to return the front USB connector assembly, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Replacing the front USB connector assembly
Use this information to replace the front USB connector assembly
To install the front USB connector assembly on 4U server models with non-hot-swap power supplies,
complete the following steps. For the 5U server model with hot-swap power supplies (Model name: 2582-
F4x), please see the next sub-section.
1. Read the safety information in
2. Turn off the server and all attached devices; then, disconnect all power cords and external cables.
3. Remove the bezel (see
4. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
5. Remove the side cover (see
6. Remove the air duct.
7. Carefully insert the front USB cable through the opening in the front of the chassis.
System x3100 M4 Installation and Service Guide
206
Front USB housing
"Safety" on page v
"Removing the bezel" on page
"Removing the side cover" on page
Spring clips
and "Installation guidelines" on page
148).
145).
30.