Four 3.5-inch hot-swap or simple-swap hard disk drive server configuration:
Figure 161. Front USB connector assembly removal for four 3.5-inch hot-swap or simple-swap hard disk
drive server configuration
Step 5.
If you are instructed to return the front USB connector assembly, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
Replacing the front USB connector assembly
Use this information to replace the front USB connector assembly.
To install the front USB connector assembly, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 116.
Step 2.
Insert the front USB connector assembly into the media cage.
Note: Refer to the illustration that applies to your particular server configuration.
242
Lenovo System x3550 M5 Installation and Service Guide
Front USB assembly