Optional Compact & Extended Hearth Panel Kit Installation Cb40E - Regency CV40E-NG Owners & Installation Manual

City series zero clearance direct vent gas fireplace
Table of Contents

Advertisement

Optional compact & extended hearth panel kit Installation CB40E
The compact or extended hearth panel kits are used in conjunction with the
compact or extended hearth framing kits. Install the compact or extended
hearth framing kit before installing the panels. The bottom drywall inishing trim
must be removed if using the hearth top glass panels. This can alternatively
be removed if looking for a clean inish up to the appliance which does not
require this trim. Ensure that any other materials being used does not extend
beyond the existing inishing trim. There are 6 screws in front and 2 per side.
Loosen all screws and lift the inishing trim up and out and recycle once re-
moved. Retighten screws.
Note: The extended framing kit and panels are shown below.
removable trim
1. Install the front panel irst, line up the screws on the back of the panel with
the keyholes on the framing kit.
Extended Hearth Glass Top Installation
The extended hearth glass top is used in conjunction with the extended hearth
framing kit. Install the extended hearth framing kit before installing the glass top.
1. Remove the outer safety barrier glass (if already installed) See manual for
detail instructions.
2 Remove screw from hearth and retain, install edge cover securing with screw
previously removed from hearth.
removable trim
3. Repeat Step 2 on opposite side.
tooltip
4. Install the glass hearth top (3 pieces in total)—apply a bead of silicone to the
top of the hearth framing before placing the three pieces of glass in place.
Handle glass carefully.
Install glass hearth top (3 pieces)
2 Hang the panel by matching the screws at the back of the panel to the cor-
3. Install the left and right side panels using the same procedure as the front
removable trim
5. Install both side panels - these are held in place by magnets.
Edge cover
6. Reverse Step 1 to reinstall outer safety barrier glass.
removable trim
Bead of silicone
responding keyholes and lower the panel until the screws rest at the bottom
tooltip
of each keyhole.
Screw at back of panel
panel.
Left and right side panel installation
tooltip
Install side panels
installation
Close up of screw in
keyhole
Keyhole on
framing unit
Glass
Side panel
City Series |
35

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cv40e-lpCb40e-ngCb40e-lp

Table of Contents