Table of Contents
Advertisement
Optional extended hearth kit Installation CB40E
NOTE: Prior to installing the extended hearth kit, both the gas/electrical should
be installed.
This optional Extended hearth kit is 8- 1/2 inches high ( without leveling legs
attached) and may be adjusted up to a maximum of 11-1/2 inches high using
the leveling feet provided.
Lay out and identify the parts for the extended hearth kit.
1. Start with the front hearth — fl ip it 90º (rib side up) to ease the installation
of the left and right legs.
Hearth Front - rib side up
2. Line up one of the hearth legs with the front hearth section. Ensure the
thumb screw is located facing the inside of the hearth and towards the top
the hearth.
Install sides with 4 screws
Thumbscrew facing inside and
towards top of hearth
3. Secure the leg with 2 screws on each side—4 screws total.
4. Repeat on other side.
Install side leg with 4 screws
5. 10 leveling legs must be installed to the hearth. See diagram below.
Min. hearth height (w/o feet) = 8-1/2"
Max. hearth height = 11-1/2"
Install the leveling legs/feet using the spacer to ensure all of them are at
the same height.
Once the 10 leveling legs/feet are spaced out, use the foot caps which are
designed to protect the fl oor surface when sliding the completed hearth
into position. These simply slide over the leveling legs/feet.
Install leveling legs/feet + foot caps
installation
Foot Height Spacer
No leveling legs
needed here
City Series |
33
Advertisement
Table of Contents
