Table of Contents
Advertisement
installation
Optional extended wood panel kit Installation CB40E
The extended wood panel kit is used in conjunction with the extended framing
kit. Install the extended framing kit before installing the panels.
Note: The minimum ceiling height must be 8 feet for the extended framing kit
and extended wood panel kit to fi t this particular application. The extended
framing kit when assembled must be set to a predetermined overall height of
93 inches from fi nished fl oor to the top of the framing kit.
1. Install the front lower panel fi rst, line up the screws on the back of the panel
with the keyholes on the framing kit.
2 Hang the panel by matching the screws at the back of the panel to the cor-
responding keyholes and lower the panel until the screws rest at the bottom
of each keyhole.
3. Install the left and right lower side panels using the same procedure as
the front panel.
Left side panel facing unit
28
| City Series
Close up of screw in
keyhole
Keyhole on
framing unit
Screw at back of panel
Right side panel facing unit
NOTE: After installation, ensure all three lower panels are at the same level
at the bottom. Also ensure that the side panels are sitting exactly at 90º and
not tilting inward or outward as the correct installation of the middle and top
panels depends on proper installation of the lower panels. Adjust panels as
needed until side and front panels are level.
Ensure fi rst row of panels (front + sides) are even with one another
NOTE: If the side panels sit lower than the front panel the bottom cover on the
side may be adjusted to correct this issue.
Loosen the 2 screws in locations shown below, push bottom panel up and
retighten screws.
Bottom Cover
4. Install the front middle panel, position the brackets at the bottom of the front
middle panel in behind the front lower panel.
5. Tighten the screws at the back of the front middle panel.
Front middle panel
Advertisement
Table of Contents
