Regency CV40E-NG Owners & Installation Manual page 34

installation
6. After installing supplied feet tilt assembled hearth over 90º.
Tip hearth back onto feet/bottom
7. If using hearth panel kit/glass hearth top, remove removable trim (5 pieces)
from the unit prior to sliding hearth into position. Loosen screws from inside
the unit to remove trim.
34 | City Series
Washer
Lock
Washer
Thumb
Screw
8. Slide assembled hearth into position around unit.
9. Temporarily place the hearth top fi nishing materials on top of the hearth
and adjust height of the hearth by adjusting the leveling legs to ensure that
the hearth top fi nishing materials line up with the outer base panels on the
appliance or the removable trim if left in place (see step 7). This must be
level at front and both sides.
10. Remove outer base panels from unit, then secure hearth to unit with 4
thumbscrews with lock washers + washers (installed from inside the unit)
in locations shown in above diagram.
Flush