Table of Contents
Advertisement
CV40E glass panel installation
1. Turn off unit and allow to cool to room temperature. Remove the safety glass
and irebox glass — see manual for instructions.
Note: The screws to secure all of the clips in these instructions will be already be
on the appliance. Simply remove and reinstall to secure all of the clips.
2. Identify panels and order of installation.
*
*3 - 1 metal panel
1 glass panel
3. Install back corner panels (1, 2) - seat smallest panel in back left corner,
repeat on other side.
back corner panel
4. Install bottom corner securing bracket as shown. Repeat step for other side.
Secure bracket
5. Install metal panel (3) into of front irebox panel.
6. Install glass panel (3) on top of the metal panel.
Secure bracket in place
metal panel
glass panel sitting on top of
metal panel installed in previous
step
7. Install one of the back panel brackets loosely with one screw (leave the
bracket loose to allow room to install the back panel behind it).
back panel bracket
8. Carefully manoeuvre the back glass panel (4) to the back wall of the irebox.
Centre the glass panel at the back of the irebox positioning underneath the
loosely installed bracket— once in position, slide the bracket in position on
the opposite side and tighten both brackets in place with one screw each.
back glass panel (4)
9. With the back panel installed, slide in one of the side glass panels (6). Push
the panel all the way to the back of the irebox ensuring that the glass is sitting
on the bottom corner bracket installed in step 4. Attach top rear bracket as
shown. Note: There is a left and right bracket. The left bracket is shown below.
side panel
10. Install side panel bracket as shown and secure with one screw.
11. Repeat steps 9-10 for other side. Clean all ingerprint marks prior to next step.
12. Install media and inner irebox glass prior to next step.
13. Install outer front panel (1) as shown. Secure Regency logo to underside
of outer front panel. The logo is simply held in with magnets.
outer front panel
14. Install outer side panels (8, 9) —these panels are held in position with
magnets. Clean all ingerprint marks on outer side and bottom panels
prior to next step.
15. Reinstall the Outer Safety Glass
installation
Top rear
Top rear bracket
bracket
tucked in behind
sitting
back glass panel
on top of
side glass
panel.
side panel bracket
location of
Regency logo
at bottom right
corner
outer side panel
City Series |
69
Advertisement
Table of Contents
