Regency CV40E-NG Owners & Installation Manual page 20

installation
2. Install Part B1 + B2 to Part A with 2 screws on each side from the front of
the unit.
Part B1 to A - screws go in from front
3. Install Part J (x 2) to Parts B1 + B2 with 4 screws each (2 top - 2 bottom) -
screw locations shown below.
Part J install to Part B1 + B2
Part J screw locations
20 | City Series
4. Slide unit into position. Check to ensure that the unit is level from front to back
and side to side and Parts A + B are square. Secure the unit with framing
to the wall studs with 2-1/2"-3" wood screws. Use 8 screws and secure to 4
studs minimum. Install venting before proceeding further with framing
kit construction. Refer to manual for venting instructions.
B1/B2 must be
secured to framing/
studs with a minimum
of 8 screws.
Secure Framing to Wall Studs with wood screws
5. Install Part O to the top of Part B2 with one screw each in location shown
below - swing inward to keep the part out of the way until further in the
installation.
Install Part O (x2) with 1 screw each
6. Install Part Q (x2) to the top of Part B2 (may have to move Part O slightly
to access screw hole on part B2).
Install Part Q (x2) with 1 screw each