Regency CV40E-NG Owners & Installation Manual page 31

9. Install the front lower panel fi rst, line up the screws on the back of the panel
with the keyholes on the framing kit.
10. Hang the panel by matching the screws at the back of the panel to the
corresponding keyholes and lower the panel until the screws rest at the
bottom of each keyhole—when in place tighten screws from inside framing.
11. Install the left and right lower side panels using the same procedure as
the front panel.
Left side panel facing unit
Close up of screw in
keyhole
Keyhole on
framing unit
Screw at back of panel
Right side panel facing unit
NOTE: After installation, ensure all three lower panels are at the same level
at the bottom. Also ensure that the side panels are sitting exactly at 90º and
not tilting inward or outward as the correct installation of the middle and top
panels depends on proper installation of the lower panels. Adjust panels as
needed until side and front panels are level.
Ensure rst row of panels (front + sides) are even with one another
FOR EXTENDED PANEL KIT ONLY: If the side panels sit lower than the front
panel the bottom cover on the side may be adjusted to correct this issue.
Loosen the 2 screws in locations shown below, push bottom panel up and
retighten screws.
Bottom Cover
12. Install the middle front panel, position the brackets at the bottom of the
middle front panel in behind the front lower panel.
13. Tighten the screws at the back of the middle panel.
Front middle panel
installation
City Series | 31