Table of Contents
Advertisement
LRI4E/HRI4E/LRI6E/HRI6E/E33
operating instructions
OPTIONAL HEARTH TRIM INSTALLATION
OPTIONAL HEARTH TRIM INSTALLATION -
VIGNETTE FACEPLATE WITH SPACER
VIGNETTE FACEPLATE WITH SPACER AND LOW PROFILE FACEPLATE
Customizing the Hearth Trim:
The Hearth Trim can be adjusted to custom fit an installation by pulling
apart the top piece from the bottom piece. Minimum height of the hearth
trim is 2" and can be adjusted up to maximum 6".
1) Cut the top of the bottom piece of the hearth trim to the appropriate
height using a metal cutting blade.
NOTE: The tab bends at the back of the top piece of the hearth trim
should be used as the measuring point to the hearth to measure the
height required.
2) Reattach the top piece of the hearth trim to the cut bottom piece by
fitting in place.
3) Similar to the front hearth trim, cut the top of the bottom piece of the spacer
brackets to the appropriate height.
4) Attach the top and bottom part of the spacer brackets and then attach these
spacer brackets to the assembled hearth trim with 3 screws.
Attach the hearth trim and spacer bracket with 3 screws each side
50 |
LRI6E / HRI6E-11 Direct Vent Gas Insert
919-560
Spacer Brackets
Spacer Brackets
5) Secure the hearth trim with a clip on its side to keep it steady as shown
in the diagram below .
Clip - secures
hearth trim
6) Line up the hearth trim with base of the unit and secure it with 3 screws
as shown below.
Align hearth trim to base of the unit and secure it with 3 screws
04/30/15
Advertisement
Table of Contents
