How To Replace A Track - Genie S-65 Service And Repair Manual
Hide thumbs
Also See for S-65:
- Service manual (344 pages) ,
- Operator's manual (61 pages) ,
- Maintenance manual (182 pages)
Table of Contents
Advertisement
September 2016
How to R eplac e a Tr ack
How to Replace a Track
Assembly
Note: Perform this procedure on firm, level surface
with the boom in the stowed position.
1
Remove the track assembly from the machine.
Refer to Repair Procedure, How to Remove a
Track Assembly.
Note: The sprocket is comprised of two halves.
Before removing the track assembly from the
machine and to ease the removal of the sprocket,
drive the machine until one complete half of the
sprocket is located above the undercarriage of the
track assembly.
2
Loosen the grease plug on the track tension
cylinder to relieve the track tension. Clean up
any grease that has spilled.
3
Remove the 2 sprocket retaining fasteners.
Remove the sprocket half from the track
assembly.
4
Carefully remove the track from the
undercarriage.
Part No. 1268492 S-60 • S-65 • S-60 TRAX • S-65 TRAX • S-60 HC • S-60X • S-60XC
Track Components
5
Use an overhead crane to lay the
undercarriage on its side with the drive
sprocket bearing assembly facing upward and
the track tension cylinder towards the ground.
6
Install the new track onto the undercarriage.
7
Attach a lifting strap from an overhead crane
to the center-point of the track, above the
sprocket.
Service and Repair Manual
97
Advertisement
Table of Contents
