Genie S-65 Service And Repair Manual page 71
Hide thumbs
Also See for S-65:
- Service manual (344 pages) ,
- Operator's manual (61 pages) ,
- Maintenance manual (182 pages)
Table of Contents
Advertisement
Service and Repair Manual
Boom Components
Boom retract cables:
10 Remove the cotter pins and clevis pins from
the boom retract cables at the platform end of
the boom.
Note: Always use a new cotter pin when installing a
clevis pin.
11 Remove the wear pad fasteners from the
upper wear pads on the number 1 boom tube.
Remove the wear pads.
Note: Pay attention to the location of each wear
pad and the quantity of shims for each one.
12 Attach a lifting strap from an overhead crane
to the platform end of the boom.
13 Raise the boom using the overhead crane and
place a wood block under the number 2 boom
tube between the number 1 and number
2 boom tubes for support. This will create
clearance between the boom tubes to remove
the retract cables.
14 Attach the cable pulling tool or a rope to one of
the boom retract cables at the pivot end of the
boom.
Note: A cable pulling tool is available through
Genie Service Parts Department (Genie part no.
94510)
15 At the platform end of the boom, pull on the
boom retract cable that has the rope attached
to it.
16 Pull the old cable completely out of the boom
tube. Remove the rope. Discard the old boom
retract cable.
17 Securely attach the rope to the same end of
the new boom retract cable.
54
S-60 • S-65 • S-60 TRAX • S-65 TRAX • S-60 HC • S-60X • S-60XC Part No. 1268492
18 At the pivot end of the boom, carefully pull the
rope with the new retract cable attached.
19 Pull the new cable towards the pivot end of the
boom until the end of the cable is at the end of
the boom tube. Remove the rope.
20 Repeat steps 14 through 19 for the other
boom retract cable.
21 At the platform end of the boom, install the
retract cables, clevis pins and new cotter pins
to the adjustment plate.
22 Remove and discard the old boom retract
pulleys from the pivot end of the boom
extension cylinder.
23 Install the new boom retract pulleys to the
pivot end of the boom extension cylinder.
24 Install the boom extension cylinder assembly
into the boom.
Note: Before lowering the extension cylinder into
the saddles of the number 1 boom tube, wrap the
boom retract cables around the pulleys.
25 Adjust the boom extend/retract cables. Refer
to Repair Procedure, How to Adjust the Boom
Extend/Retract Cables.
September 2016
Advertisement
Table of Contents
