Track Components - Genie S-65 Service And Repair Manual

Service and Repair Manual

Track Components

Track Compon ents
10- 1 Track Ass embly , S- 60 TRAX and S- 65 TRAX
10-1
Track Assembly, S-60 TRAX and
S-65 TRAX
How to Remove a Track
Assembly
Note: Perform this procedure on firm, level surface
with the boom in the stowed position.
1 Select a track assembly to remove. Loosen
and remove as many sprocket retaining
fasteners as possible from the hub adapter.
2 Drive the machine in either direction just
enough to access the remaining fasteners. Do
not remove the retaining fasteners.
3 Chock the tracks at the opposite end of the
machine to prevent the machine from rolling.
4 Center a lifting jack of ample capacity
(20,000 lbs / 10,000 kg) under the drive
chassis between the tracks.
96 S-60 • S-65 • S-60 TRAX • S-65 TRAX • S-60 HC • S-60X • S-60XC Part No. 1268492
5 Lift the machine until the tracks are off the
ground and then place jack stands under the
drive chassis for support.
6 Attach a lifting strap from an overhead crane
to the center-point of the track assembly,
above the sprocket.
7 Remove the remaining sprocket retaining
fasteners from the hub adapter.
8 Carefully remove the track assembly from the
drive hub and set aside.
Crushing hazard. The track
assembly could become
unbalanced and fall when
removed from the machine if not
properly supported by the
overhead crane.
September 2016