How To Install A Type "A" Flex Plate - Genie S-65 Service And Repair Manual

Service and Repair Manual
Engines
How to Ins tall a T ype " A" Flex Plate
How to Install a Type "A" Flex
Plate
1 Install the flex plate onto the engine flywheel
with the raised spline towards the pump.
2 Ford models: Torque the flex plate mounting
bolts in sequence to 14 ft-lbs / 19 Nm. Then
torque the flex plate mounting bolts in
sequence to 20 ft-lbs / 27 Nm.
Deutz models: Torque the flex plate mounting
bolts in sequence to 28 ft-lbs / 38 Nm. Then
torque the flex plate mounting bolts in
sequence to 40 ft-lbs / 54 Nm.
Perkins models: Torque the flex plate
mounting bolts in sequence to 49 ft-lbs / 66
Nm. Then torque the flex plate mounting bolts
in sequence to 70 ft-lbs / 95 Nm.
Ford and Deutz Models
Perkins Models
60 S-60 • S-65 • S-60 TRAX • S-65 TRAX • S-60 HC • S-60X • S-60XC Part No. 1268492
3 Install the pump coupler onto the pump shaft
with the set screw toward the pump. Leave the
appropriate gap between coupler and pump
end plate for your engine.
1 pump
2 pump shaft
3 pump coupler
4 flex plate with raised spline
5 engine flywheel
6 3/16 inch / 4.8 mm gap - Diesel Models
0.080 inch / 2 mm gap - Ford Models
4 Apply Loctite® removable thread sealant to
the pump coupler set screw. Torque the set
screw to 61 ft-lbs / 83 Nm.
5 Proceed to Repair Procedure, How to Install
the Pump and Bell Housing Assembly.
September 2016