1-5-8 Drive section
(1) Detaching and refitting the drum drive unit K and the drum drive unit MCY
Procedure
Detaching the drum drive unit K
1. Remove the rear upper cover and the
rear lower cover (see page 1-5-65).
2. Remove the connector.
3. Release the wire saddle.
4. Remove three screws.
5. Remove the drum drive unit K.
*: Do not have a shaft part alone when you
carry drum drive unit K. (Have the hous-
ing.)
*: Put support on the tip of the shaft so that
the shaft may become the horizontal
when you put drum drive unit K on the
table etc.
Connector
Wire saddle
Screw
Screws
Screw
Screws
1-5-70
2LK/2LN/2LM/2LC
Figure 1-5-113
(Shaft portion)
Drum drive unit K
(housing portion)
Figure 1-5-114