Image Formation Problems - Kyocera TASKalfa 3050ci Service Manual

1-4-3 Image formation problems

If the part causing the problem was not supplied, use the unit including the part for replacement.
(1) No image
appears (entirely
white).
See page 1-4-88
(6) Black streaks
are printed verti-
cally.
See page 1-4-91
(11) The leading
edge of the
image is con-
sistently mis-
aligned with the
original.
See page 1-4-93
(16)Fusing is loose. (17)Image is out of
See page 1-4-94
(2) No image (3) Image is too
appears (entirely
black).
See page 1-4-89
(7) Streaks are (8) One side of the
printed horizon-
tally.
See page 1-4-91
(12)The leading (13)Paper is wrin-
edge of the
image is spo-
radically mis-
aligned with the
original.
See page 1-4-93
(18)Image center
focus.
See page 1-4-95
(4) The back-
light.
See page 1-4-90 See page 1-4-90
(9) Spots are
print image is
darker than the
other.
See page 1-4-92 See page 1-4-92
(14)Offset occurs.
kled.
See page 1-4-93 See page 1-4-94
does not align
with the original
center.
See page 1-4-95
1-4-87
2LK/2LN/2LM/2LC
(5) White streaks
ground is col- are printed verti-
ored. cally.
See page 1-4-91
(10)Image is
printed.
See page 1-4-92
(15)Part of image is
See page 1-4-94
blurred.
missing.