Offset Occurs; Part Of Image Is Missing; Fusing Is Loose - Kyocera TASKalfa 3050ci Service Manual

(14) Offset occurs.

Print example
Deformed or worn cleaning
blade in the drum unit.
Defective transfer belt clean-
ing.
Defective fuser unit.
Wrong types of paper.

(15) Part of image is missing.

Print example
Paper damp.
Paper creased.
Drum condensation.
Dirty or flawed drum.
Dirty transfer belt.
Dirty transfer roller.
Dirt on the back surface of the
contact glass and scanner
mirror.

(16) Fusing is loose.

Print example
Wrong types of paper.
Flawed heat roller or press
roller.
Defective pressure springs.
Defective fuser IH.
Causes
Replace the drum unit (see page 1-5-36).
Replace the transfer belt unit (see page 1-5-41).
Replace the fuser unit (see page 1-5-45).
Check if the paper meets specifications. Replace paper.
Causes
Check the paper storage conditions.
Replace the paper.
Perform the drum refresh.
Perform the drum refresh.
Flawed drum. Replace the drum unit (see page 1-5-36).
Clean the transfer belt. Replace the transfer belt unit if it is
extremely dirty (see page 1-5-41).
Clean the transfer roller. Replace the transfer roller if it is
extremely dirty (see page 1-5-43).
Clean the contact glass and scanner mirror.
Causes
Check if the paper meets specifications, replace paper.
Replace the fuser unit (see page 1-5-45).
Check procedures/corrective measures
Check procedures/corrective measures
Check procedures/corrective measures
1-4-94
2LK/2LN/2LM/2LC