Kyocera TASKalfa 3050ci Service Manual page 243

Code
0000 Initial jam
0100 Secondary paper feed request
time out
0101 Waiting for process package
to become ready
0102 Waiting for toner package to
become ready
0103 Waiting for the image-sustain-
ing package to become ready
0104 Waiting for conveying pack-
age to become ready
0105 Registration sensor not
detected
0106 Paper feeding request for
duplex printing time out
0107 Waiting for fuser package to
become ready
0108 Waiting for option package to
become ready
0110 Paper conveying unit open
0111 Front cover open
0112 Duplex cover open
0113 Paper conveying cover open
0114 Bridge cover open
0115 Bridge eject cover open
0120 Receiving a duplex paper
feeding request while paper is
empty
0121 Exceeding number of duplex
pages circulated
0131 MP lift sensor upper limit
detection
0200 Machine sequence error
0210 PF paper conveying cover
open
0211 Paper conveying cover open
*: Refer to figure 1-4-1 for paper misfeed indication (see page 1-4-1).
Contents
The power is turned on when a sensor in the con-
veying system is on.
Secondary paper feed request given by the con-
troller is unreachable.
Process package won't become ready.
Toner package won't become ready.
The image-sustaining package won't become
ready.
Conveying package won't become ready.
Activation of the registration sensor (on/off) is
undetected for 90 s during printing.
Paper feeding request for duplex printing given by
the controller is unreachable.
Fuser package won't become ready.
Option package won't become ready.
The paper conveying unit is opened during print-
ing.
The front cover is opened during printing.
The duplex cover is opened during printing.
The paper conveying cover is opened during
printing.
The bridge cover is opened during printing.
The bridge eject cover is opened during printing.
Paper feed request was received from the duplex
section despite the absence of paper in the
duplex section.
The controller issued the duplex section a request
for more pages than the duplex print cycle con-
tains.
MP lift sensor 1 (DPLS1) does not turn on within
specified time of the MP lift plate rising.
A sequence error has caused.
The PF paper conveying cover is opened during
printing.
The paper conveying cover is opened during
printing.
Conditions
1-4-3
2LK/2LN/2LM/2LC
Jam
location*
-
-
-
-
-
-
-
-
-
-
E
-
F
E
J
J
F
F
D
-
E
E